+91 97244 57680
sales.zeelengineers@gmail.com
Mon - Sat, 9am - 7pm
+91 97244 57680
sales.zeelengineers@gmail.com
Mon - Sat, 9am - 7pm
 |
Small in volume, light weight, reasonable design and novel pattern. It consists of a series of products, so output torque matches with all kinds of Pneumatic devices and valves.
|
|
There are two keyway apart 90° in the inner hole of worm gear so as to be convenient for customer to choose relative position between gear operator and valve
|
|
Pull out the position pin and rotate off center device with 180° to realize pneumatic drive by positioning pin acted or to realize manual drive in the opposite way.
|
|
The gear operator is filled with special lubricant before leaving lubricant before leaving the factory. It is solid sealed with valve after installation possessing dustproof and waterproof function with protecting grade IP65.
|
Contact Us
The bottom of gear operator should be connected with valve, racket surface connected with cylinder, valve stem go through the inner hole of worm gear and the square on the end of stem matches with square hole of cylinder.
Working procedures: The cylinder drives valve stem and worm gear rotating together when pneumatic drive and worm shaft meshes with worm gear to drive valve stem rotating along with piston of cylinder moving when manual drive. When pneumatic drive, pull out the pneumatic drive by worm gear rotating following with pneumatic valve stem. Just make the worm shaft mesh to realize manual drive.
No mesh may occur when move handle toward outside by 180° and close the worm shaft, please rotate hand-wheel by an angle to move it.
| MODEL | TORQUE (NM) |
| AMO – 0.5 | 150 |
| AMO – 2.5 | 400 |
| AMO – 3.5 | 850 |
| AMO – 4.5 | 1200 |
| AMO – 5.5 | 1800 |